Download User Manual in PDF

 

            DEVICE

RS-NAGV

 

Emergency stop

 

                APPLICATIONS

and safety gate monitoring relay

 

                APPROVALS

CE, TÜV, UL, C-UL

 

                CONTACTS

6 normally open safety, 4 normally auxiliary closed

 

               

Opposite polarity between channels

 

                SPECIAL CHARACTERISTICS

Cyclial monitoring of the function

 

 

LED indicators for status and supply diagnostic

 

                LED

Channel 1 and channel 2

 

               

24 V  AC / DC (without galvanic disconnection/ safety resistor)

 

                OPERATING VOLTAGE

24 V DC (without galvanic disconnection / electronic fuse),

 

               

24,  110-127, 230 V AC (with galvanic disconnection/transformer)

 

                POWER CONSUMPTION

ca. 6 VA

 

                START UP DELAY / FALLBACK TIME

< 200 ms / ca. 30 ms

 

                CONTACT CAPACITY max.

4 A, 240 V AC, 60 V DC

 

                CONTACT CAPACITY min. at 24V DC (*)

10 mA

 

                SIMULTANEITY

Simultaneous protective door contacts : ca. 75 ms

 

                ENVIRONMENTAL TEMPERATURE

- 25°C to + 55°C

 

                SWITCHING CAPACITY

1000 VA (resistive load), 120 W

 

                CONTACT SECURITY

4 A quick acting

 

               

 

 

 

 

                OPERATING MODE

                (*) We offer all devices who have a CONTACT

                 CAPACITY of min. 100 mA at 24 V DC with

                 hard gold-plated contacts. In this way the

                 CONTACT CAPACITY of min. 100 mA is only 4 mA.

                Please ask our sales team!

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

                CONNECTION DIAGRAM

A supply voltage must be applied at terminals A1 and A2 in order to operate the device. If this is done there is a voltage of 24V DC at terminals T11, T12 and T22 must be wired as shown in the application examples. To start the unit terminal T11 must be bridged with terminal T34 by means of a closing contact or terminal T34 must receive a 24V DC impulse (short time bridging of the connection terminals T11-T34). If this is done contacts 13-14, 23-24, 33-34, 43-44, 53-54 and 63-64 close and 71-72, 81-82, 91-92 and 101-102 open. The LEDs channel 1 and channel 2 illuminate. Through terminal X1 and X2 the function of   an external contactor can be monitored. Terminals X1 and X2 must be bridged in order to operate the device.

 

 

 

 

 

 

 

 

 

 

 

                FUNCTION CIRCUIT DIAGRAM

 

                Certifications according to

                Safety relevant substance data

                Depending on wiring (only max. values are given)

EN ISO 13849-1: PLe, Cat.4

MTTFd: 74,61 years / high, DC: 99% / high

CCF: achieved